STAGE 109

 Return to the BUILD


“In this assembly session you will assemble the front right wheel arch and attach it to the front of your model car.

This stage will be just like the previous one, just on the right side of the car.

Contents


Parts

Materials: Everything in this stage is plastic.

Build


The Front Right Wheel Arch

Stage 109.1

Align the screw holes in the large tab of the Front Right Wheel Arch (Part 2) to the end of the Front Right Wheel Arch (Part 1) as shown, then secure the parts together with two (2) AP screws:

Stage 109.2

Align the screw holes in the tab of the Front Right Wheel Arch (Part 3) over the matching posts of the Front Right Wheel Arch (Part 2) and secure it in place with two (2) AP screws.

CAUTION: Again, the image in the instructions is wrong here. They show this Part 3 fitting behind Part 2, but it needs to be on top, as shown:

Stage 109.3

Retrieve your Charger and carefully turn it upside down on a soft cloth. Then, fit this Front Right Wheel Arch assembly down into the front right wheel opening as shown. Secure the Front Right Wheel Arch assembly into place with two (2) AM screws:

Stage 109.4

Secure the Front Lower Panel to the Front Right Wheel Arch (Part 3) with two (2) AP screws:

Stage 109.5

Fit the Front Right Wheel Arch (Part 1) to the rear of the front right wheel opening, align the rounded tabs over the screw holes, and secure it into place with two (2) CP screws, as shown:

Stage 109.6

With this Wheel Arch now installed, reattach the Front Right Wheel with the one (1) IM screw and push the Hub Cap back into place.

Thoughts


This Wheel Arch went in much easier as I did not have to mess with the headlight wiring!

Next Up


 Stage 110 – Left/Right Struts, Antenna Rod/Base, Compressor Unloader Valve, Bonnet Latch Rings

Leave a Reply

Your email address will not be published. Required fields are marked *