Return to the BUILD

“In the following assembly session you will prepare the firewall panel that you will then mount on your model.”




Materials: The Firewall is the only metal part in this stage – the rest are plastic.

Assembly Guide (Digital Version)


Assembling the Firewall

Stage 25.1

Fit one of the Bonnet Safety Catches into this hole of the Firewall. Secure from below with one (1) CM screw.

The base of the Bonnet Safety Catches is hexagonal and you want this aligned so the tiny indents in the catch line up with the Firewall, as shown:

Also, make sure the tiny hole on the end of the catch is parallel to the Firewall:

This is also your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Stage 25.2

Attach the other Bonnet Safety Catch to the other end of the Firewall the same way, with one (1) CM screw:

Stage 25.3

Push the pin on the Relay into the matching hole and recess of the Firewall, as shown. No screw or glue is needed here:

Stage 25.4

Push the D-shaped pin of the Firewall Grounding Connector into this matching hole of the Firewall, as shown. No screw or glue here either:


MOM:  While this stage was easy, I can’t help but get a little giddy as we add a little more to the front end of the car!

Next Up

 Stage 26 – Brake Power Booster/Brackets, Master Cylinder, Brake Hoses

Leave a Reply

Your email address will not be published. Required fields are marked *