STAGE 28

 Return to the BUILD


“In this assembly session you will attach the horn and expansion tank to the front panel of the engine housing.”

 

Contents


Parts

Materials: The Front Panel of the Engine Housing and the Horn Mount are metal – the other parts in this stage are plastic.

Build


Attaching the Engine Housing III

Stage 28.1

Fit the Horn to the Horn Mount Bracket as shown, and secure with one (1) CM screw.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Stage 28.2

Align the Horn assembly against these two small tabs of the Front Panel of the Engine Housing (Radiator Support) as shown. Secure this part with one (1) AP screw:

Stage 28.3

Attach the Expansion Tank to the Radiator Support, aligning the pin and screw hole as shown, and secure with one (1) AP screw:

Stage 28.4

Slide one of the Expansion Tank Hose onto the pin at the top of the Expansion Tank:

Thoughts


MOM: Another stage complete!

Next Up


 Stage 29 – Radiator, Radiator Filler Neck/Cap/Hoses

Leave a Reply

Your email address will not be published. Required fields are marked *