STAGE 42

 Return to the BUILD


“In this assembly session you will assemble the right rear wheel and attach it to the corresponding side of your model’s rear axle.”

 

Contents


Parts

Materials: The Rims are metal, the Rear Right Tyre is hard rubber, and the rest of the parts are plastic.

Build


Mounting the Right Rear Wheel

Stage 42.1

Push the Tyre Valve onto the pin of the Rim (Outside).

We have built these wheels before, the steps are the same:

Stage 42.2

The Rear Right Tyre has the words ‘inside’ written on one side and ‘outside’ written on the other. Push this rim through the ‘outside’ of the tire:

Stage 42.3

Fit the Rim (Inside) through the ‘inside’ side of the tire matching the pins to the holes of the Rim (Outside).

Note this tiny notch in the Rim (Inside) for the Tyre Valve to fit into:

Secure the two rims together with three (3) HM screws.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Stage 42.4

Retrieve your Chassis assembly. Slide this wheel assembly over the right end of the Rear Axle assembly and secure it into place using one (1) IM screw through the Washer and then through the wheel and into the axle.

Stage 42.5

Push the Hub Cover into the center of the wheel:

Thoughts


We just build a rear wheel, so this felt very familiar. However, we have reached a ‘milestone’ with a rolling chassis!

Next Up


 Stage 43 – Lower Fuel Tank Panel, Battery Holder Cover

Leave a Reply

Your email address will not be published. Required fields are marked *