Return to the BUILD
“In this assembly session you will attach some new components to the right door.“
These steps will be the same process we followed in Stage 85 for the other door.
Contents
Parts
Materials: All of these parts are plastic.
Assembly Guide (Digital Version)
Build
Right Side Inner Door Panel
Stage 91.1
Press the pin of the Door Handle into the matching hole of the Door Handle Base, as shown:
Stage 91.2
Press the pins of this Door Handle assembly into the rectangular recess of the Inner Panel Right Door, as shown:
Stage 91.3
Retrieve your Inner Section of the Right Door assembly from the previous stage. Fit this Inner Panel to the Inner Section, as shown:
Stage 91.4
Secure the Inner Panel to the Inner Section from the other side with six (6) AP screws, as shown:
Stage 91.5
Fit the three tabs of the Lower Window Profile into the matching slots along the top of the Inner Section, as shown:
Stage 91.6
- From the other side, fit the posts of Profile Mount Bracket 1 into the rightmost two square holes of the Inner Section
- Secure Mount Bracket 1 into the Frame Trim with two (2) OP screws
- Then, fit the post of Profile Mount Bracket 2 into the leftmost square hole of the Inner Section
- Finally, secure Mount Bracket 2 into the Frame Trim with one (1) OP screw
Thoughts
All of these stages just to assemble a couple of doors. Well, at least we’ve done all of this before so we are very familiar with it!
Next Up
Stage 92 – Chrome Guide/Deflector Trim, Deflector Glass/Knob/Mount Bracket